Quadcopter Component

.....

.....

Description: Highly efficient DC Motor without brushes with a rating of 1800KV . This motor can be used in various designs llike UAV, Hovercrafts etc. .....

Description: It is system used in connection with ESC's for the connecction with Quadcopter. It is having good conductivity. It is metalic and golden in color. It is having high performance....

Essentially, it is a gear motor that can be controlled by an RC servo controller. It is not normally used as an actuator, as there is no way of commanding it to move to a particular position, as a standard RC servo do...

Description : For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. As the simplified version of NAZA-M, it inherits the high reliability and stab...

Description: Electronic Speed Control (ESC) with an output of 30 Amperes that can be used to control Brushless DC Motors. .....

Description: 1. 6 Channel Transmitter and receiver 2. Designed for flight control 3. Operating at 2.4 GHz .....

Features:   2.4ghz radio receiver with true Advanced Frequency Hopping Spread Spectrum (AFHSS) technology Channels: 6 Channels Compatible with the factory TX modules on these radios: FS-TH9x/TH...

Fly-sky USB Simulator Cable For Flysky FS-GT3B/GT3/GT2 GT3B .....

Fast, safe, secure way to wrap wiring harnesses. Protects and insulates. Great variety of top pro quality heat shrink tubing. Will shrink up to half of original diameter. Size 10 inch .....

Description: It is a dedicated electronic circuit used for charging lithium polymer batteries. .....

The Turnigy Accucel 6 Balance Charger utilises quality FET's and resistors to accurately balance and charge LiPoly and NiMH batteries. The Accucel-6 will handle LiPoly/LiFe up to 6S and NiMH/NiCd up to 15S and shows...

Description: Lithium-Polymer (LiPo) is a high discharging battery that can be used as a power supply to your robots like quadcopters etc. .....

.....

.....

.....

.....

Designed in house by the HobbyKing Enginerds, this handy power distribution board has the same foot print as our Multri-rotor control boards and is the ultimate solution for tidy power distribution wiring. Simply use ...

Description: These are dedicated propellers for designing Quadrotors having a length of 10 inches and a pitch of 4.5 inches in dimensions. .....

These are dedicated propellers for designing Quadrotors having a length of 8 inches and a pitch of 4.5 inches in dimensions. .....

Description: It is the first pre-programmed flight controlled board designed for controlling UAVs. .....

Description: It is a pre-programmed controller board with on board accelerometer and Gyro sensor especially designed for UAVs. It can be used to design model aircrafts, drones, quadcopters etc. .....

Description: It is the first pre-programmed flight controlled board designed for controlling UAVs. .....

Description: It is a frame especially designed for quadcopters that contains a dedicated PCB for connections and colored legs for proper orientation. .....

.....

.....

This 3-wire harness can be used to add a toggle switch between any two devices that can be connected with “JR” style servo connectors. One side of the switch has a lead with a female connector, while the other side ha...

.....

This compact USB ISP programmer is for ATMEL, AVR 51, ATMega, ATTiny, ATMEGA8 and ATMEGA128 plus many more. The USB interface is achieved via an ATMEGA processor and the rest is done in firmware. Special Features:...

Description: COLOR CMOS Wireless: Camera Apparartus: 1/3.1/4 picture sensor System: PAL/CCIR NTSC/EIA Validity Pixel: PAL: 628x582 NTSC: 510x492 Pictrue area: PAL : 5.78x40199mm NTSC: 4.6...